Electric heater Pahlén 3 kW Aqua Compact 30, Stainless Steel

Description

Electric flow heaters are designed for heating water in swimming pools and hot tubs. They work by heating the water as it flows through the heating element. Read more

Product code: 141600

Description
Related products

Electric Heater Pahlén 3 kW Aqua Compact 30, Stainless Steel

Electric flow heaters are designed to heat water in swimming pools and hot tubs. They work by heating the water as it passes through the heating element. The heater is supplied with an adjustable thermostat with a temperature range of 0 - 45°C, overheating protection with a max. temperature of 60°C, and a flow switch that cuts off the power when the water flow is lower than 90 l/min.

Electric flow water heaters are specially designed in their construction for heating pool water, or water in other water circuits with a flow rate and temperature up to 45°C. Each heater must be installed in the electrical system behind a residual current device. We therefore recommend supplementing the unit with a suitable type of automatic control. Suitable for private pools up to 100 m³.

It has a heating cartridge made of stainless Incoloy 825 material. Incoloy 825, also known as nickel alloy 825, is an alloy of nickel, iron, and chromium with small amounts of molybdenum, copper, and titanium. This combination gives Incoloy 825 enhanced corrosion resistance in the most demanding environments. It ensures resistance to both reducing and oxidizing acids such as sulfuric and phosphoric acid.

Advantages:

uses the conversion of electrical energy into heat energy
the heater body is made of reinforced thermoplastic
has a heating cartridge made of stainless Incoloy 825 material
100% leak tested
not suitable for use with salt water
equipped with a thermostat up to 45°C and a thermal fuse
equipped with a flow switch that monitors water flow

Use

For heating indoor and outdoor pools
For heating hot tubs
For chlorinated water

Package Contents

Electric heater
Thermostat for regulating water temperature up to 45°C
Flow switch
2 pcs PVC 50 mm connecting fittings
2 wall brackets
2 gaskets
Instructions

Installation Diagram

The heater must be installed at least 200 mm below the normal water level in the pool, see example.
The connection must be made using PVC pipes with Ø50 mm (inner Ø42 mm) with a minimum straight length of 200 mm before and after
the heater. Install the heater horizontally so that it is completely filled with water.
If the heater is mounted in contact with flammable material, a non-combustible board must be placed between the heater and the wall, etc.
This board must extend 10 cm beyond the heater on all sides. The heater must not be covered.
The installation must be carried out so that water can be drained from the heater.
The heater is installed on the return pipe to the pool, behind the filter. Do not install any shut-off valve between the heater and the pool. If
necessary, install a check valve.
Chlorine, oxygen, etc. dosing must take place AFTER the heater to prevent corrosion.