Electric heater Pahlén 18 kW Aqua Compact 180T, Titanium

Description

Electric flow heaters are designed for heating water in swimming pools and hot tubs. They work by heating the water as it flows through the heating element. Read more

Product code: 141605T

Description
Related products

Pahlén Electric Heater 18 kW Aqua Compact 180T, Titanium

Electric flow heaters are designed to heat water in swimming pools and hot tubs. They work by heating the water as it flows through the heating element. The heater is supplied with an adjustable thermostat with a temperature range of 0 - 45°C, overheating protection with a max. temperature of 60°C, and a flow switch that cuts off the power when the water flow is lower than 90 l / min.

Electric flow water heaters are specially designed in their construction for heating pool water, or water in other water circuits with a flow rate and temperature up to 45°C. Each heater must be installed in the electrical system behind a residual current device. We therefore recommend supplementing the unit with a suitable type of automatic control. Suitable for private pools up to 100 m³.

Advantages:

uses the conversion of electrical energy into heat energy
the heating body is made of thermoplastic with increased strength.
fitted with a titanium heating cartridge. Titanium offers the best corrosion resistance of all available materials.
100% leak tested
this type of heater is suitable for abnormal stress and higher chlorine concentration. It can be used in combination with any water treatment system, especially electrochemical salt chlorinators, etc.
equipped with a thermostat up to 45°C and a thermal fuse
equipped with a flow switch that monitors the water flow

Use

For heating indoor and outdoor pools
For heating hot tubs
For chlorinated water

Package Contents

Electric heater
Thermostat for regulating water temperature up to 45°C
Flow switch
2 pieces of PVC 50 mm connection fittings
2 wall brackets
2 seals
Instructions

Installation Diagram

The heater must be installed at least 200 mm below the normal water level in the pool, see example.
The connection must be made using PVC pipes with Ø50 mm (inner Ø42 mm) with a minimum straight length of 200 mm before and after
the heater. Install the heater horizontally so that it is completely filled with water.
If the heater is mounted so that it is in contact with a flammable material, a non-combustible board must be placed between the heater and the wall, etc.
This board must extend 10 cm beyond the heater on all sides. The heater must not be covered.
The installation must be carried out so that water can be drained from the heater.
The heater is installed on the return pipe to the pool, behind the filter. Do not install any shut-off valve between the heater and the pool. If necessary
install a check valve.
Chlorine, oxygen, etc. dosing must take place AFTER the heater to prevent corrosion.