Electric Heater Pahlén 18 kW Aqua Compact 180, Stainless Steel

Description

Electric flow heaters are designed for heating water in swimming pools and hot tubs. Their operation is based on heating the water as it flows through the heating element. Read more

Product code: 141605

Description
Related products

Electric Heater Pahlén 18 kW Aqua Compact 180, Stainless Steel

Electric flow heaters are designed to heat water in swimming pools and hot tubs. They work by heating the water as it passes through the heating element. The heater is supplied with an adjustable thermostat with a temperature range of 0 - 45°C, overheating protection with a max. temperature of 60°C, and a flow switch that cuts off the power when the water flow is lower than 90 l/min.

Electric flow water heaters are specially designed for heating pool water, or water in other water circuits with flow and a temperature up to 45°C. Each heater must be installed in the electrical system behind a residual current device. We therefore recommend supplementing the unit with a suitable type of automatic control. Suitable for private pools up to 100 m³.

It has a heating element made of stainless Incoloy 825 material. Incoloy 825, also known as nickel alloy 825, is an alloy of nickel, iron, and chromium with small amounts of molybdenum, copper, and titanium. This combination gives Incoloy 825 enhanced corrosion resistance in the most demanding environments. It ensures resistance to both reducing and oxidizing acids such as sulfuric and phosphoric acid.

Advantages:

converts electrical energy into heat energy
the heater body is made of reinforced thermoplastic
has a heating element made of stainless Incoloy 825 material
100% leak tested
not suitable for use with salt water
equipped with a thermostat up to 45°C and a thermal fuse
equipped with a flow switch that monitors water flow

Use

For heating indoor and outdoor pools
For heating hot tubs
For chlorinated water

Package Contents

Electric heater
Thermostat for regulating water temperature up to 45°C
Flow switch
2 pieces of PVC 50 mm connection fittings
2 wall brackets
2 seals
Instructions

Installation Diagram

The heater must be installed at least 200 mm below the normal water level in the pool, see example.
The connection must be made using PVC pipes with Ø50 mm (inner Ø42 mm) with a minimum straight length of 200 mm before and after the heater.
Install the heater horizontally so that it is completely filled with water.
If the heater is mounted against flammable material, a non-combustible board must be placed between the heater and the wall, etc.
This board must extend 10 cm beyond the heater on all sides. The heater must not be covered.
Installation must be carried out so that water can be drained from the heater.
The heater is installed in the return line to the pool, behind the filter. Do not install any shut-off valve between the heater and the pool. If necessary, install a check valve.
Chlorine, oxygen, etc. must be dosed AFTER the heater to prevent corrosion.