 |
34/49 |  |
Plate Heat Exchanger AISI316 G-PWT-VA 70 - 55 °C / 74 kW
Plate Heat Exchanger AISI316 G-PWT-VA 70 - 55 °C / 74 kW
Description
Thanks to their large surface area, plate heat exchangers are especially suitable for low-temperature heating systems such as solar systems, geothermal systems, heat pumps, and other alternative and innovative ... Read more-
Plate Heat Exchanger AISI316 G-PWT-VA 70 - 55 °C / 74 kW
Thanks to their large surface area, plate heat exchangers are especially suitable for low-temperature heating systems such as solar systems, geothermal systems, heat pumps, and other alternative and innovative heating systems. Thanks to their design, they are suitable for both small and large pools. Bolted plate heat exchangers operate with high efficiency and low pressure losses. They deliver the best heating results in combination with a pool heat pump or solar heating. Water flow in plate heat exchangers is lower and, compared to tube heat exchangers, they also have a smaller connection diameter. However, the water is heated to a higher temperature in them. Unlike traditional designs, a brazed heat exchanger consists only of surfaces that actively contribute to heat transfer, resulting in a significant increase in overall efficiency.
G-PWT-VA plate heat exchangers must be installed in a vertical position. Any other position prevents sufficient water flow and proper heat exchange. The exchanger connection threads must not be subjected to any excessive pressure. If the supply piping is long and could place a load on the threads, the pipes must be supported.
By design, these heat exchangers are specially developed for heating pool water, water in hot tubs and spas, or for underfloor heating. The exchanger design is engineered to restrict flow so as to maximize heat transfer while minimizing pressure in the heating system.
Advantages
- Made of stainless steel
- High quality
- Increased energy efficiency
- Chemical resistance
- Must be integrated directly into the pool water circuit
Use:
- pools
- hot tubs
Power kW
Heat output 75 kW Primary inlet / outlet temperature 55 / 34.5 °C Heat output 54 kW Primary inlet / outlet temperature 45 / 30.3 °C Heat output 34 kW Primary inlet / outlet temperature 35 / 26 °C
Technical parameters
- Power: 74 kW
- Flow rate (primary): 3.2 m3 / h
- Pressure loss (primary): 0.14 bar
- Flow rate (secondary): 4.0 m3 / h
- Pressure loss (secondary): 0.28 bar
- For pools up to: 70 - 80 m3
- Pool water temperature: 20 °C
- Installation: Bypass
- Number of plates: 17
- Area: 0.62 m2
- Maximum operating temperature: 90 °C
- Max. pressure 1000 kPa: 10 bar
- Bonded gasket: max. 150 °C
- Weight: 26 kg
-
Related products
Availability:
Availability:
Availability:
Availability:
Availability:
Availability:
Availability:
Availability:
