 |
2/16 |  |
Aseko ASIN Aqua DOSE - dosing station
Aseko ASIN Aqua DOSE - dosing station
Description
Asin Aqua DOSE with flow sensor is a compact device for pools up to 250 m3, which takes care of pool water. Read more
-
Aseko ASIN Aqua DOSE - dosing station
Asin Aqua DOSE with flow sensor is a compact device for pools up to 250 m3 that takes care of your pool water. It doses a pre-set amount of disinfectant at user-defined time intervals and maintains the selected pH value. Thanks to this, the water is always crystal clear and flawless. The set value and measured pH are displayed on the large touchscreen, where all required parameters are also set in a simple dialog mode. It includes a pH probe, dosing pumps, and a control flow meter. DOSE - time-based dosing of disinfectant (hourly disinfectant dose).
Advantages:
- touchscreen display
- easy operation
- multilingual menu
- for outdoor and indoor pools
- compact design
- peristaltic pumps
- measurement, dosing, and pH adjustment in the pool
- control flow meter with integrated filter for measured water
- easy installation
- advanced safety features
Pool Water Treatment:
- Dosing of chlorine or non-chlorine disinfectant in set time intervals
- pH regulation using a pH probe
Package Contents
- Complete control unit with pumps
- 1x Long Life pH probe
- 2x shut-off fittings for 1/4" (6.35 mm) pipe / thread
- 2x injection valve
- 2x weights for chemical containers
- 1x transparent PE connecting pipe 1/4“
(6.35 mm) 20 m
Measured Water Connection
The pool water intended for measurement must be connected to the ASIN AQUA. Connect the measured water supply after the pump and pre-filter. The shut-off valve is installed in the G 1/4" plug. For connecting the measured water to your ASIN AQUA, Aseko provides a unique Speedfit connection fitting. To connect, push the connecting pipe into the Speedfit connector and then secure it by pulling on the tube. To disconnect, press and hold the circular collet and pull out the connecting pipe.
WARNING: use a sharp knife to prepare the pipe ends.
Using scissors or pliers deforms the end of the tube and leads to leaks.WARNING: tighten by hand only. Do not use pliers or other tools.
- To ensure leak-tight joints, cut the pipe at a 90° angle.
- Use a sharp knife to cut the plastic. The cut must be clean and smooth.
- Connect the water inlet to the measured water filter connection and the outlet to the connection on the probe tank. Make sure the measured water pressure does not exceed 1.5 bar.
- The outlet from the tank can be carried out:
- after filtration
- to a pressure-free line (overflow tank)
Technical Specifications
- Power supply: 230 V / 50 Hz
- Power consumption: 14 VA
- Fuse: T80 mA
- Overvoltage category: II
- Protection rating: IP50
- Operating temperature and humidity: +5 to +40°C / 60%
- Weight: 2.2 kg
- Mounting: wall-mounted
- Controlled values: pH, disinfectant
- Pump output: 60 ml / min. (max. 1 bar)
- Measured water pressure: max. 1.5 bar
-
Related products
Availability:
Availability:
Availability:
Availability:
Availability:
Availability:
Availability:
Availability:
