Package Contents

• PP60 CLF dosing pump
• CLF probe
• Peristaltic pump
• Injection valve x1
• Suction set for 20 l canister
• Shut-off fitting x2
• Wall plugs and screws
• Connecting PE pipe 1/4“ (6.35 mm) - transparent

Connecting the Measured Water

The pool water intended for measurement must be brought to the PP60 CLF probe. The shut-off fitting is installed in a D=50 plug with G1/4“ thread, glued into a T-piece. Tighten only by hand. Do not use pliers or any other tools.

• Inlet of measured water connect to the pipe after the pump, before the filter and coagulation mixer.
• Outlet of measured water connect to the pipe after filtration and heating, or to the overflow tank or skimmer.

To connect the measured water to your PP60 CLF, use the 1/4“ (6.35 mm) connecting pipe included in the package. For connecting the measured water pipe to the PP60 CLF, Aseko provides a unique Speedfit fitting.

• Connection push the connecting pipe into the Speedfit connector and then secure it by pulling on the tube.
• Disconnection press and hold the Speedfit release ring and pull out the connecting pipe
   
• Inlet of measured water into the PP60 CLF connect the connecting pipe to the Speedfit fitting on the measured water filter.
• Outlet of measured water from the PP60 CLF connect the connecting pipe to the Speedfit fitting on the probe tank

After connecting and opening the water supply, the PP60 CLF is ready to measure the disinfectant level in your pool so that it meets hygiene limits.