 |
111/128 |  |
VA pH, ORP simulator
-
pH, ORP Simulator
The probe simulator is intended exclusively for checking the functionality and accuracy of a dosing/measuring station, not as a calibration device. The dosing/measuring station must always be calibrated to the probe to prevent possible measurement deviations. The simulator can simulate pH and ORP values by connecting to any station via a BNC connector.
- pH / ORP
- Predefined pH values 4 - 9
- ORP 0 - 900
Package contents:
- 1x pH/ORP Simulator
- 2x Coaxial cable BNC-V/BNC-V75 0.5 m
- 2x AAA MAXEL alkaline battery
Description of device elements
1) “ON/OFF” button
- Button for turning the simulator on. In the ON state (switched on), the button lights up red and is in the lower position. In the OFF state (switched off), the button does not light up and is in the upper position.
2) “Test” button
- This button is used to verify functionality at the pH and ORP inputs of the measuring station. When pressed, the output impedance of the pH and ORP connectors increases to 100 MΩ.
3) pH rotary switch
- Used to set the desired pH value on the pH connector.
4) ORP rotary switch
- Used to set the desired ORP value on the ORP connector.
5) pH and ORP connectors
- These are connectors on the top side of the simulator used to connect the coaxial cables (included in the package).
- Left connector - ORP
- Right connector - pH
Warning before using the simulator
The simulator is NOT intended as a calibration unit! Using it does not allow you to calibrate the measuring/dosing station! If the measuring station was calibrated to a probe, the measured values on the measuring station may differ from the values set on the simulator.
Technical specifications
- Product type: Probe simulator
- Simulated values: stepwise - pH, ORP
- Protection rating: IP 20
- Weight: 0.3 kg
